Sign in with
Sign up | Sign in
Your question
Solved

Kingston 16GB DT 101 G2 problem

Last response: in Storage
Share
April 12, 2014 5:18:32 AM

i have problem on my Kingston 16GB When I insert the DataTraveler into the USB port on my PC, the unit is recognized but without any space and closed , when i try to open it , gives me message to format it and when i try to format it doesn't work i try every thing .
April 12, 2014 5:58:52 AM

Try using diskpart to format your flash drive.

1) Open a command prompt (run as administrator).
2) Type in diskpart and press enter
3) type in list disk and press enter
4) use the select x command to pick your flash drive (substitute x with the corresponding disk number of your flash drive in the list) and press enter
5) type in clean and press enter
6) type in create partition primary and press enter
7) type in active and press enter
8) type in format fs=ntfs label=MYFLASHDRIVE quick and press enter
9) type in assign and press enter
10) type in exit and press enter
and you're done.
m
0
l
April 12, 2014 7:37:20 AM

thanks my friend

but when i type select
4) use the select x command to pick your flash drive (substitute x with the corresponding disk number of your flash drive in the list) and press enter

it gives me 4 options

Disk
Partition
volume
vdisk

and i cant chose any my flash drive I


m
0
l
Related resources

Best solution

April 12, 2014 7:45:24 AM

type in select disk x (replace x with the exact disk number of your flash drive)...
Share
August 18, 2014 2:52:00 PM

trekzone said:
Try using diskpart to format your flash drive.

1) Open a command prompt (run as administrator).
2) Type in diskpart and press enter
3) type in list disk and press enter
4) use the select x command to pick your flash drive (substitute x with the corresponding disk number of your flash drive in the list) and press enter
5) type in clean and press enter
6) type in create partition primary and press enter
7) type in active and press enter
8) type in format fs=ntfs label=MYFLASHDRIVE quick and press enter
9) type in assign and press enter
10) type in exit and press enter
and you're done.




after pressing enter on phase 5) i get after a looooong blinking silence, an error message. A semaphore shity timing expiration..


my solution is to take back to the seller the coaled up memory and shove it up their asses!!

m
0
l
!