I purchased a “kit” from TigerDirect that included a H105 cooler and a Thermalake case (Thermaltake Versa H22 Mid-Tower Case w/ Window - SPCC Material, 7 x Expansion Slots, 3 x 5.25" External Drive Bays - CA-1B3-00M1WN-00).
What is abundantly clear now that the H105 will not fit into the Thermaltake case. TigerDirect has not been helpful in addressing this issue at all, they do not seem concerned that their ‘kit’ contained incompatible parts.
I hope I get some good advice and guidance from you. I will have to mount the H105 externally somehow (or get another case).
Is it possible to disconnect the hoses (so I can route them through openings in the back of the case) and then reconnect them? If not, I could cut an opening in side panel for hoses, and mount the radiator on top of the case. Or I just buy a new case.
I would welcome your suggestions/recommendations on to mount the cooler?
Also, the WD HDD (that came with 'kit') needs a 8-pin rectangular power connector, the Kingwin PSU (that came with 'kit') doesn't have this. Does anyone what adapter I need for this?
Thanks.
What is abundantly clear now that the H105 will not fit into the Thermaltake case. TigerDirect has not been helpful in addressing this issue at all, they do not seem concerned that their ‘kit’ contained incompatible parts.
I hope I get some good advice and guidance from you. I will have to mount the H105 externally somehow (or get another case).
Is it possible to disconnect the hoses (so I can route them through openings in the back of the case) and then reconnect them? If not, I could cut an opening in side panel for hoses, and mount the radiator on top of the case. Or I just buy a new case.
I would welcome your suggestions/recommendations on to mount the cooler?
Also, the WD HDD (that came with 'kit') needs a 8-pin rectangular power connector, the Kingwin PSU (that came with 'kit') doesn't have this. Does anyone what adapter I need for this?
Thanks.