Sign in with
Sign up | Sign in
Your question

gtx 770 problem. Can't find a solution.

Last response: in Graphics & Displays
Share
April 21, 2014 11:49:34 AM

So, I just finished building my first pc yesterday and everything runs fine. Except for the gpu. When I first booted up the pc there was no video no matter what I did until I tried taking out the gpu (gtx 770). It runs perfectly without the card installed but whenever I put the card in all I get is a black screen and the monitor says "no signal".

I've been searching for a fix to the problem for hours but can't seem to find anything that works. One thing I've been concerned about is that the power supply might not be large enough. Reading through other threads I've seen that if the pci-e cables aren't connected or if the system doesn't have enough power, the screen should show some sort of error message upon startup, though I don't get any error message, just the blank screen. I have the Corsair Builder 600W 80+ Bronze Certified ATX Power Supply which is the very minimum wattage for the gpu so is it possible that this is the problem?

Any other ideas or solutions would be much appreciated.

specs:

CPU: Intel Core i5-4440 3.1GHz Quad-Core Processor
Motherboard: MSI H81M-P33 Micro ATX LGA1150 Motherboard
Memory: A-Data XPG V1.0 8GB (1 x 8GB) DDR3-1600 Memory
Storage: Western Digital Caviar Blue 1TB 3.5" 7200RPM Internal Hard Drive
Video Card: Zotac GeForce GTX 770 2GB Video Card
Case: BitFenix Colossus Venom Window (Black) ATX Full Tower Case
Power Supply: Corsair Builder 600W 80+ Bronze Certified ATX Power Supply
Optical Drive: Samsung SH-224DB/BEBE DVD/CD Writer
April 21, 2014 11:58:52 AM

First question when you install the card are you going into the bios and disabling the on board video ?
m
1
l
April 21, 2014 12:11:40 PM

Quote:
First question when you install the card are you going into the bios and disabling the on board video ?


I'm not exactly sure what you mean. Should I go into the bios and disable my on board video before I insert the card into my motherboard?
m
0
l
April 28, 2014 2:17:37 PM

I hope you fixed your problem but yes that was my suggestion you have to disable onboard card then you save and the video out should go to your pci device.
m
0
l
Related resources
!