L life24 Reputable May 2, 2014 16 0 4,510 May 5, 2014 #1 Hi, How can i measurement 'Power Good' option with multimeter? Thank you
I ivanjacob Honorable Jan 3, 2014 156 0 10,760 May 5, 2014 #2 I don't really understand your question. Could you go a bit more in depth? Upvote 0 Downvote
L life24 Reputable May 2, 2014 16 0 4,510 May 5, 2014 #3 ivanjacob : I don't really understand your question. Could you go a bit more in depth? Thank you , I want measurement Power_Good in power supply. http://en.wikipedia.org/wiki/Power_good_signal Upvote 0 Downvote
ivanjacob : I don't really understand your question. Could you go a bit more in depth? Thank you , I want measurement Power_Good in power supply. http://en.wikipedia.org/wiki/Power_good_signal
I ivanjacob Honorable Jan 3, 2014 156 0 10,760 May 5, 2014 #4 You will need to do this http://www.overclock.net/t/96712/how-to-jump-start-a-power-supply-psu-test-a-power-supply-and-components And then put the positive cable from the multimeter in the grey hole and the negative in one of the black holes. Upvote 0 Downvote
You will need to do this http://www.overclock.net/t/96712/how-to-jump-start-a-power-supply-psu-test-a-power-supply-and-components And then put the positive cable from the multimeter in the grey hole and the negative in one of the black holes.
L life24 Reputable May 2, 2014 16 0 4,510 May 5, 2014 #5 ivanjacob : You will need to do this http://www.overclock.net/t/96712/how-to-jump-start-a-power-supply-psu-test-a-power-supply-and-components And then put the positive cable from the multimeter in the grey hole and the negative in one of the black holes. Thank you, I have the below multimeter and when i measurement Power Good signal which option would be? Upvote 0 Downvote
ivanjacob : You will need to do this http://www.overclock.net/t/96712/how-to-jump-start-a-power-supply-psu-test-a-power-supply-and-components And then put the positive cable from the multimeter in the grey hole and the negative in one of the black holes. Thank you, I have the below multimeter and when i measurement Power Good signal which option would be?
L life24 Reputable May 2, 2014 16 0 4,510 May 5, 2014 #7 ivanjacob : Red and 20. Thank you,Power good value is based on the delay in ms, that a power supply takes to become fully ready. Power good values are often considered abnormal if detected lower than 100ms or higher than 600ms. Upvote 0 Downvote
ivanjacob : Red and 20. Thank you,Power good value is based on the delay in ms, that a power supply takes to become fully ready. Power good values are often considered abnormal if detected lower than 100ms or higher than 600ms.
L life24 Reputable May 2, 2014 16 0 4,510 May 6, 2014 #8 I want get Powe good signal based MS. Upvote 0 Downvote