Sign in with
Sign up | Sign in
Your question
Solved

Bad spray job removal HELP!!

Tags:
  • Paint
  • Spray
  • Bad
  • Brother
  • Systems
Last response: in Systems
Share
May 13, 2014 9:16:29 PM

HELP!!!! My brother freaking gave my pc side panels a bad spray paint job. i cant seem to get it off! I dont wana sand it because it will scratch up my pc a lot, so what can i do to remove this paint, any suggestions?

More about : bad spray job removal

May 13, 2014 9:18:01 PM

Sanding its probably the easiest option, and actually painting it after.

Or you can buy a replacement panel.
m
0
l
May 13, 2014 9:20:02 PM

Gam3r01 said:
Sanding its probably the easiest option, and actually painting it after.

Or you can buy a replacement panel.


i tried looking but i guess there are none for nzxt phantom 410
and what grit sandpapers will i need im assuming lower grit then go over it with a higher
m
0
l
Related resources

Best solution

May 13, 2014 9:21:59 PM
Share
May 13, 2014 9:23:43 PM

It depends on the quality of the paint. 120 would be a good place to start, and 200 maybe for the finish.
Thats what I used on my desk I built, 120 on an angle grinder to get all the rust etc off from the shop, and 200 to prepare surface. Same concept.
m
0
l
May 13, 2014 9:24:14 PM

You could try paint gun wash. I use it to clean engine parts all the time. Just be careful it's pretty caustic stuff.
m
0
l
May 13, 2014 9:26:33 PM

Thank you all for the help ima take the sanding route C:
m
0
l
!