- Oct 9, 2013
- 2,566
- 0
- 13,460
Up until now whenever my PC turned on it went through the manufacturer screen with BIOS, setup, boot options underneath before coming up with the Windows 8 boot-up sequence. However, now when I turn it on the screen is blank but it comes up after Windows 8 fully boots. Last night I opened up my PC to rearrange the cabling to make it cleaner just because I wanted to. However when I started up the computer the screen was blank and only turned on after Windows supposedly fully booted. I tried mashing F10 during boot-up but it doesn't seem to recognise I tried to enter the BIOS.
I haven't removed any plugged-in cables from my computer but I did switch around the connector cables for my SSD and HDD so they looked clean inside. Could this be the problem? Would I only need to switch them around again?
Here's an image of my PC:
http://i.imgur.com/k4RqhN1.jpg
Before I switched around the cabling:
http://i.imgur.com/t2WZqFS.jpg
I haven't removed any plugged-in cables from my computer but I did switch around the connector cables for my SSD and HDD so they looked clean inside. Could this be the problem? Would I only need to switch them around again?
Here's an image of my PC:
http://i.imgur.com/k4RqhN1.jpg
Before I switched around the cabling:
http://i.imgur.com/t2WZqFS.jpg
Facebook
Twitter
Instagram