Couple questions about Sentey CS1-1398 (low end case)

saitamonje

Reputable
May 25, 2014
54
0
4,640
Hello everyone.

I've recently bought that case at a very good price because it was an outlet (it has a little scratch in one side). But I have doubts about where and how to put coolers.

First, the case has place for two bottom coolers. The one below the graphics card is 120 mm and the one below the hdd area is 80mm. Should those go as air intakes or exhausts?

And then, on the side, it has a side air duct, for the processor. On Sentey's website they say that it is for the processor to receive fresh air from the outside, but as the cpu cooler exhausts air I think that's just not possible. So, is the air duct any good? Perhaps it prevents the PSU from sucking hot air from the processor, am I right?

And, my last question is, if I replaced the air duct with a cooler, should it be an intake or exhaust? The case has a cooler below the duct as an intake (guess it is for the GPU)

http://www.sentey.com/en/cs1-1398
Thats the info Sentey provides, but I found it not very accurate. Too many air intakes and only one active air exhaust. Correct me if I'm wrong.

I'm asking this questions because I'll be doing some overclock (nothing extreme) and I want the best air flow on the case.

I would be very thankful for any answers about this, since I havent found much info on the net.

Thanks in advance
 
Solution
If the bottom fan has good intake (i.e. not sitting on carpet), I would think the bottom mount fan would be just as good as the front mounted fan. Not as much HDD/SSD cooling, but more airflow for the rest of the components.
I imagine the air you were feeling when you put your hand over the CPU cooler's fan was just air turbulence created by the air "bouncing off" the MB. Looking at the case a little better, I really don't see any problems you should have with cooling if you use a top or rear with bottom fan arrangement.

clutchc

Titan
Ambassador
By 'coolers' I presume you are referring to case fans, yes? The normal orientation for case fans is front, bottom, side: intake. Top and rear: exhaust. The existing small side fan should be enough for all but the hottest of cases. The most important spot for an exhaust fan is in the top opening or the rear opening since warm air collects at the top of most cases.

Unless you've changed the stock cooler on your CPU, it intakes air and blows it over the heat sync, it does not exhaust air as you state. The air duct on the side panel is to allow fresh outside air for the CPU cooler rather than a mix of outside and inside air. Personally, I'd probably remove the duct. It will be in the way and useless for an aftermarket cooler which you will need if you plan on OC'ing the processor.

At minimum for OC'ing I'd put a rear or top exhaust and a front intake.

 

saitamonje

Reputable
May 25, 2014
54
0
4,640
Thanks for your answer. Yes, I meant fans by 'coolers'. English is not my mother language, sorry.

The problem is that that case doesn't have space for a front fan, so, I'm stuck with the bottom, side, and rear fans. Kind of weird fan distribution, though. Perhaps I could do some modding to it and make space for a top fan, but that would be another thread.

And thanks for the info about the cpu fan, btw. I always thought that it exhausted air because it felt that way when I put my had near it..
 

clutchc

Titan
Ambassador
If the bottom fan has good intake (i.e. not sitting on carpet), I would think the bottom mount fan would be just as good as the front mounted fan. Not as much HDD/SSD cooling, but more airflow for the rest of the components.
I imagine the air you were feeling when you put your hand over the CPU cooler's fan was just air turbulence created by the air "bouncing off" the MB. Looking at the case a little better, I really don't see any problems you should have with cooling if you use a top or rear with bottom fan arrangement.
 
Solution