Hi
I recently purchased an R9 270X. I installed the GPU and ran into a few errors.
Before installing, I uninstalled the GT 640 drivers and then installed the GPU, it said "No Signal" I then thought that it must be the intel HD drivers, so I uninstalled them and then reinstalled the GPU again, "No Signal". I then thought that it was the Motherboard, so I installed the GT 640 and it showed a display. I noticed how the R9 270X Requires a minimum of 4GB of system memory, I do have four, but it is clocked to 650MHz. I also noticed that with the HDMI cable, it doesn't go in as far as the GT 640s did, so I tried a bit harder and then with a different HDMI cable still no signal.
I was wondering what order I do this in because right now I have the GT 640 installed with all of the drivers installed and I am wanting to do this again the clean way because I messed it up the first few times.
Oh and the fans are spinning normally, the 2x 6 pin power connectors are inserted the right way. Just an order of how I should install the GPU from here.
Any help is appreciated as I just want to get this up and running!
I recently purchased an R9 270X. I installed the GPU and ran into a few errors.
Before installing, I uninstalled the GT 640 drivers and then installed the GPU, it said "No Signal" I then thought that it must be the intel HD drivers, so I uninstalled them and then reinstalled the GPU again, "No Signal". I then thought that it was the Motherboard, so I installed the GT 640 and it showed a display. I noticed how the R9 270X Requires a minimum of 4GB of system memory, I do have four, but it is clocked to 650MHz. I also noticed that with the HDMI cable, it doesn't go in as far as the GT 640s did, so I tried a bit harder and then with a different HDMI cable still no signal.
I was wondering what order I do this in because right now I have the GT 640 installed with all of the drivers installed and I am wanting to do this again the clean way because I messed it up the first few times.
Oh and the fans are spinning normally, the 2x 6 pin power connectors are inserted the right way. Just an order of how I should install the GPU from here.
Any help is appreciated as I just want to get this up and running!