Microsoft teredo Interface Adapter-- I haven't see a real solution to this problem!

Slavv

Reputable
Jun 23, 2014
9
0
4,510
I have similar issue on my Dell Windows 7. Microsoft Teredo Interface adapter shows yellow triangle with exclamation point, showing error code 10. My Internet works with Ip4 and my Modem works with Ip4 only.
I did follow advice, that I see on this site and on others- ((go to device manger, click on Action , go to legacy hardware--(then click next and next again it will then scan and find nothing click next on the screen after that.
Wait a minute and you will see a list of hardware appear, scroll down and choose network adapters then click next, then from the left column choose Microsoft then in the right hand column scroll down and choose Microsoft Teredo Tunneling Adapter, then click next and this will install it., etc))))))) I am not going to repeat the whole instructions here.
BUT-

It has installed Microsoft Teredo Interface Adapter #2 also with an yellow triangle and exclamation point. When it got installed I got this message- Microsoft Teredo Interface Adapter was installed , but may not work properly (code 10). So, anyway, you can keep on installing Microsoft Teredo Interface Adapter forever, and it still will show code 10 and an yellow triangle. Somehow, it has to do with Microsoft, they must update with a new patch. otherwise, it will be "Mary Go around". I tried to contact Dell and my PC is out of Warranty. I am 100% certain that this error message is not only with Dell, as I see so many of you guys are experiencing the same issue. It is with Microsoft. I am sure tht we all have different PC brand names, not only Dell, so if we have the same problem it must be Microsoft's fault. I tried to contact Microsoft and they refer me to manufacturer of my PC.
I visited about 10 other sites with this problem, and I haven't seen that someone was able to resolve this issue. Any brilliant ideas out there?

 

athlonman00

Honorable
Jan 20, 2014
76
0
10,660
http://answers.microsoft.com/en-us/windows/forum/windows_7-hardware/teredo-tunneling-pseudo-interface-this-device/757db042-c91e-464c-b963-c1f442fdf925 has some instructions that might be helpful. I'll list them here so you don't need to float around looking for them:

1. Open command prompt with administrator credentials (Find CMD and right-click - Run as Administrator).
2. Enter netsh environment. Type "netsh" and ENTER.
3. "int teredo" and ENTER
4. "set state disabled" and ENTER.
5. Open Device Manager and uninstall "Teredo Tunneling Pseudo-Interface".
6. Open command prompt with administrator credentials once again.
7. netsh + ENTER.
8. "int ipv6" + ENTER
9. "set teredo client" + ENTER
10. Open Device Manager and Scan for new hardware.
11. Select "Show hidden devices" from the View menu. You will now see that it is present without errors with any luck.