CPU Fan Symbol on Case leads

jag1182

Reputable
Jun 12, 2014
6
0
4,510
How can I distinguish the case fan lead which is intended for the CPU fan from the leads for the other case fans? The leads are labeled with a rectangle on the left, a rectangle on the left, a rectangle on the right, and there is one more lead but I don't recall which of the three positions the label rectangle is in.
 
Solution
The images probably indicate the positions of the fans as you're looking at the side of your case with the front to your right. The leads with rectangles on the right are probably for you front fans and vice versa. I doubt there is a case fan lead for your CPU fan as they normally get plugged directly into your motherboard at the fan header labeled "CPU_Fan". There may be another header right next to it labeled "CPU_Opt" - that's for an additional CPU fan if you have one (as in a dual fan CPU cooler). The CPU fan header will normally be located above the CPU.

Normal setups have the CPU fan controlled directly from the motherboard by way of the bios. Fan speed is driven by the CPU temp. There are other setups for controlling the...
The images probably indicate the positions of the fans as you're looking at the side of your case with the front to your right. The leads with rectangles on the right are probably for you front fans and vice versa. I doubt there is a case fan lead for your CPU fan as they normally get plugged directly into your motherboard at the fan header labeled "CPU_Fan". There may be another header right next to it labeled "CPU_Opt" - that's for an additional CPU fan if you have one (as in a dual fan CPU cooler). The CPU fan header will normally be located above the CPU.

Normal setups have the CPU fan controlled directly from the motherboard by way of the bios. Fan speed is driven by the CPU temp. There are other setups for controlling the CPU fan, but I would do some research before attempting them as, if you get it wrong, you could fry your CPU.
 
Solution

jag1182

Reputable
Jun 12, 2014
6
0
4,510
Volcanoscout: Thank you very much. This fits - turns out there are just the right number of connectors with symbols in the correct positions to match the fans in the case. I was really more concerned about the CPU fan, and since NZXA gives no instruction on these in the case documentation (hint, hint, if you're reading this, NZXA) I was afraid one of these leads was for the CPU, as they were in a previous case. (That case wouldn't turn on the computer using the front switch unless the CPU was routed through it.) Anyway, thanks for the help.