I am working on a m5a99x pro motherboard and was able to get the back bracket installed with ease, however, while attempting to do the front of the motherboard screws, (using the cross screw method) but once I get one screw in, I am unable to get enough pressure down in order to screw in the remaining 3 screws. What am I doing wrong?
CM EVO 212 CPU Fan Install Help
- Thread starter elemancer
- Start date
Solution
maddogfargo
Splendid
- Nov 28, 2006
- 3,344
- 8
- 22,965
1) Don't screw it all the way in at first. Just start the screw and give it 1-2 turns.
2) Make sure the centring pin is in the right spot. If it pops out it will be sitting too high on the cooler and prevent other screws from reaching.
2) Make sure the centring pin is in the right spot. If it pops out it will be sitting too high on the cooler and prevent other screws from reaching.
TRENDING THREADS
-
-
News Windows 11 will reportedly display a watermark if your PC does not support AI requirements- Started by Admin
- Replies: 6
-
Question r9 390 a good budget option since rx 580s are overpriced?- Started by jordanbuilds1
- Replies: 3
-
-
Question a boot loop for IBM x3550 m4 but it immediately turns off
- Started by abdus1
- Replies: 2
Facebook
Twitter
Instagram