- Jun 28, 2014
- 13
- 0
- 4,520
I have installed an DeepCool Gamaxx 300 Cooler on my Q6600 and i set in BIOS on an G41M-P26 MSI motherboard in Cell Menu :
The FSB from 299 to 333 so it runs at 3 Ghz almost, and at 1333 FSB (motheboard supports it)
For FSB : RAM i set 1.60 ( they now work at 1066 Mhz, they are 1333 Mhz Kingmax, cheap ones.
But at 1332 and 332 for CPu they won't work as the PC won't boot or show anything on monitor, but it starts and show that overclocked has failed.
If i set the CPU to 333 and ratio so they will match the RAM will show 1334 and i was scared to try it.
The cooling is good, in Intel Diagnostic Tool temps are not getting higher than 52 degrees Celsius
Tested Prime95 for few minutes the 1024k Testes were OK.Temps around 60.
So if the Motherboard and RAM supports 1333 should i try the ratio that shows 1334 for RAM?
The FSB from 299 to 333 so it runs at 3 Ghz almost, and at 1333 FSB (motheboard supports it)
For FSB : RAM i set 1.60 ( they now work at 1066 Mhz, they are 1333 Mhz Kingmax, cheap ones.
But at 1332 and 332 for CPu they won't work as the PC won't boot or show anything on monitor, but it starts and show that overclocked has failed.
If i set the CPU to 333 and ratio so they will match the RAM will show 1334 and i was scared to try it.
The cooling is good, in Intel Diagnostic Tool temps are not getting higher than 52 degrees Celsius
Tested Prime95 for few minutes the 1024k Testes were OK.Temps around 60.
So if the Motherboard and RAM supports 1333 should i try the ratio that shows 1334 for RAM?
Facebook
Twitter
Instagram