Need quick advice on this build

Kirodawg

Reputable
Jun 30, 2014
8
0
4,510
http://pcpartpicker.com/p/nYKt99

I will be fitting a 240mm rad in the front of the case as an intake(after removing the HDD cage), with a fan on the bottom of the case near the PSU set as a intake as well, with the 2 fans up top as exhaust, along with the rear fan set as exhaust. I know the case does not natively support watercooling but I have seen it done on a few review sites. Would cooling/temps be ok in that type of a setup? However, I am wondering if I should go with the XSPC AX240 rad or the EX240 rad. Not sure if the slightly longer AX240 would cause a clearance issue with the top of the 5.25 bay where the 750 pump/reservoir would be.

Also for watercooling, I am getting some UV green tubing instead of UV coolant, since people say that stuff is bad. This will be my first watercooling build, so to recap, all I need for that is just everything in the kit, plus some normal distilled water from the grocery store, and a kill coil??

Also the PSU I want is not listed on there but it is the 750w version, which I hope could be able to run 2 r9 280x in XF sometime in the future without problems(along with CPU OC).