Sign in with
Sign up | Sign in
Your question

scanner not recognized after computer wakes from hibernate

Tags:
  • Windows XP
  • Computers
  • Scanners
  • Hibernate
  • Printers
Last response: in Windows XP
Share
August 10, 2014 3:29:59 PM

using all in one printer scanner HP1175cse

Scanner works correctly until computer goes into hibernate. After starting from hibernate I get this

Error message:

"The computer cannot detect the scanner or camera. Please make sure the device is turned on and is properly connected to the computer."

Temporary resolve:

-turn off printer
-disconnect printer
-turn off computer
-reconnect printer
-turn on printer
-restart computer

But, problem is solved only until computer goes back into hibernate. When the computer is awakened, problem is back. To resolve, entire set of steps must be repeated to enable scanning again. How do I keep scanner recognized through hibernate mode ?


More about : scanner recognized computer wakes hibernate

August 10, 2014 4:23:31 PM

My old AGFA 1212p (uses LPT port as eppwdm) scanner disables hibernation and standby states. It does it in its drivers, when I try to enter to one of these states, the Windows displays a message that scanner's drivers disallow to this.

I think that your hardware may require such restriction in its drivers, but it wasn't implemented.
m
0
l
August 10, 2014 5:18:51 PM

I don't think that is my problem but thanks for replying
m
0
l
August 11, 2014 8:41:52 PM

bump
m
0
l
!