- Aug 14, 2014
- 2
- 0
- 4,510
I am building a pc for gaming purpose and here are the specifcations :
CPU- Amd Fx 8350
MotherBoard- Asus M5A99FX Pro R2.0
PSU - Corsair CX -750
GPU - Sapphire R9 270x Toxic 2gb
Ram = Corsair DDR3 4gb x2 (CMZ4GX3M1A1600C9)
Hdd - Seagate 500gb Hdd
Problem = I've assembled the components and now when i turn it on following follows:
- all the fans starts running ; the CPU fan , cabinet fans and even the GPU fans
- then suddenly, for some unknown reason the GPU fans turn off
- the motherboard, after a moment gives 1 long beep and then 3 small beeps [and sometimes i here the fourth beep a moment after the third beep]
-after all the beeps done, the GPU fans starts rotating again, the gpu light turns on as all were before the beeps
And so i get no output on the moniter. This beep pattern,according to the manual is = VGA not Detected.
Things i tried and 've got me no result[strike][/strike]
- i took out the mother board out of the case and tried it on the box over the supporting screws
- tried 1 RAM at a time , switched the RAM and the ports.
- trying the different PCIe port
- clearing CMOS with and without battery
- reseating the GPU for 4 times
- connecting only one PCI cable rather than 2
- connecting only the four pins out of 8 for the ATX power
- turning the pc on and off for like half of a day with some hope that it may start for once.
Any one with any solution, i'd be grateful.
CPU- Amd Fx 8350
MotherBoard- Asus M5A99FX Pro R2.0
PSU - Corsair CX -750
GPU - Sapphire R9 270x Toxic 2gb
Ram = Corsair DDR3 4gb x2 (CMZ4GX3M1A1600C9)
Hdd - Seagate 500gb Hdd
Problem = I've assembled the components and now when i turn it on following follows:
- all the fans starts running ; the CPU fan , cabinet fans and even the GPU fans
- then suddenly, for some unknown reason the GPU fans turn off
- the motherboard, after a moment gives 1 long beep and then 3 small beeps [and sometimes i here the fourth beep a moment after the third beep]
-after all the beeps done, the GPU fans starts rotating again, the gpu light turns on as all were before the beeps
And so i get no output on the moniter. This beep pattern,according to the manual is = VGA not Detected.
Things i tried and 've got me no result[strike][/strike]
- i took out the mother board out of the case and tried it on the box over the supporting screws
- tried 1 RAM at a time , switched the RAM and the ports.
- trying the different PCIe port
- clearing CMOS with and without battery
- reseating the GPU for 4 times
- connecting only one PCI cable rather than 2
- connecting only the four pins out of 8 for the ATX power
- turning the pc on and off for like half of a day with some hope that it may start for once.
Any one with any solution, i'd be grateful.
Facebook
Twitter
Instagram