PC POWER DOWN in game

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630
last evening i was playing Diablo 3 for a bout 6-7 Min when suddenly it just power it self down . i couldn't power it back un unless i jank the power cable out and then put it back in .. after it booted back i just search in event log for any Critical or any other error messages as only 2 i got was carnel related .. i noticed that it happens only in game cos i spent 1 hour in web browsing for any info about this incident but when i went back in game it did it again .. the thing is i was playing a bit earlier DayZ SA and all was good .. i Have
Corsair CM750 watt psu
Sapphire R9 280X Vapor x Tri x GPU
2x4gb dd3 sticks
2x 500Gb sata HDD
1155 intel 3470 3.2Mhz 6mb cash
MOB AsRockz77 Extereme4

2 corsair Air series 140MM blue led fans
3 Stock 140mm zalaman z9 Plus case fans
1 White 140mm (No LED) exhaust fan


all games i played ran spot on on this set up ( SE3 , BF3,BG4 WD, D3 ROS,
all games are around 55-65 FPS depends on a game

I checked the temp's

GPU- 67*- 70*(Max)

Cpu 55* - 67*

As CPU cooler i use : Zalman CNPS5X Performa CPU Fan

the PSu i have about 3 ish months now
Just in case i got Corsair RM1000 Watt psu coming down this Wednesday

*****************UPDATE**********
I did a stress test on a cpu and it pass with a decent score so i am sure it's not about temps
Please Advise :)
 
Solution
I'm sure it's not the CPU overheating, 70c max for a sandy bridge isn't anything to worry about. However, this problem might be related to the PSU, it might be faulty.

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


What cooler you would recommend not only for this CPU but for future upgrades
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


i swapped stock for Zalman CNPS5X Performa a while a go as i tough it might be better might have a look on 212 evo
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


i will clean the Old paste off this evening and reapply the fresh amount i usually spread it around with old business card so it's even . after then i will see the Bios for restart the fan and then i hope all goes well
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630



I usually just clean the cpu with Soft tissue
and if must use the liquid to clean the cpu is there any alternatives ?

 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


Okey i will look in work for some and then i will post back the results

i still have 1 can of compressed gas for the case cleaning from dust so will blow that one in 1st
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


as i mentioned in early answers i will 1st try to reseat the Cooler and reset the fan if than wont help then i will know where is the problem

it's shame if it will be a PSU as it's less then 4 months old
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


Right i just cleared the CPU change the paste also checked is the PSu fan turning on and spinning Yes it is now i put all back together sprayed some gass to gett dust out

Now The temp at the moment in webb browsing and watching an Blueray movies is prox 30-33

Will update after i launch a game an play for a bit

 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630
The Pc booted again The reading on CPu wast arround 40 ish 8-10 min in game ( Diablo 3 ) i checked the Event Log and come up to theese error's

The driver \Driver\WudfRd failed to load for the device SWD\WPDBUSENUM\{3acb5ca9-9cca-11e3-be65-806e6f6e6963}#0000000006500000.

The driver \Driver\WudfRd failed to load for the device SWD\WPDBUSENUM\{3acb5ca9-9cca-11e3-be65-806e6f6e6963}#0000000000100000.

ant then

The system has rebooted without cleanly shutting down first. This error could be caused if the system stopped responding, crashed, or lost power unexpectedly.

Crash dump initialization failed!

all temps was in good order so i assume it's PSU


 

Ytyoussef

Distinguished
Try this:
"To resolve this issue, set the Windows User Mode Driver Framework service Startup type setting either to Automatic. To do this, follow these steps:
Click Start, click Run, type services.msc in the Open box, and then click OK.
In the list of services, right-click Windows User Mode Driver Framework, and then click Properties.
Click the General tab.
In the Startup type box, click Automatic, and then click OK.
On the File menu, click Exit."
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630


well then the only issue i am facing is PSU :((( Damm it had only less then 4 months
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630



i have done exacly as you asked
but tthis step u provided me stands for them 2 errors Right ?
 

Eriks Abzinovs

Honorable
Aug 27, 2013
69
0
10,630
Resolution: 1920x1080 (FS) - AA:0 samples

BURN-IN SCORE: 5398 points

53650 frames, 59 FPS, 75°C

FPS: min:57, max:65, avg:59 - OPTIONS: DynBkg

AMD SI TAHITI XT (1002-6798)

Catalyst 14.4 - 14.10.1006-140417a-171099C (4-17-2014)

core:1100MHz, mem:1500MHz

Intel(R) Core(TM) i5-3470 CPU @ 3.20GHz

3200 MHz - CPU speed

8075 MB - System memorie

so it's deffo not an GPu or CPU fault + it didn't power down douring the test on HIGH load so it seems that the psu is reactin good again .. Hmmm
only changes i made is Turned off CCC Overrride

Im lost now ? :(

*****UPDATE*****


PC lost power literary after i finished the post ... i swapted the Cable that goes in to the wall socket and will ren another test tomorrow and if the power still bailing out then i must say Bye Bye to this PSU :(
 

Latest posts