Hi Guys,
Im wiring up a stand with 3 layers of 5050 led stips. And need to know if using a 12v 1amp power supply is enough.
So each layer is identical. Im going to describe from LED to 44key controller.
-(4) 5050 LED strips 3-led section strips. I cut at every cut line.
-(4) 4-Pin Male/Female Connector Wire Cable (Link: http://goo.gl/UwS1sB )
-(1) Female 1 To 4 Connector Splitter 4 Pins 4 Way to connect the (4) LED strips together (Link: http://goo.gl/GOuIRj )
-(1) 44key Controller to control the lights on each layer seperatly.
Now all (3) 44key controllers are being connected using this (Link: http://goo.gl/69ERFu )
From my calculation i need a 12v 1Amp power supply? This right?
Thanks, Tama.
Im wiring up a stand with 3 layers of 5050 led stips. And need to know if using a 12v 1amp power supply is enough.
So each layer is identical. Im going to describe from LED to 44key controller.
-(4) 5050 LED strips 3-led section strips. I cut at every cut line.
-(4) 4-Pin Male/Female Connector Wire Cable (Link: http://goo.gl/UwS1sB )
-(1) Female 1 To 4 Connector Splitter 4 Pins 4 Way to connect the (4) LED strips together (Link: http://goo.gl/GOuIRj )
-(1) 44key Controller to control the lights on each layer seperatly.
Now all (3) 44key controllers are being connected using this (Link: http://goo.gl/69ERFu )
From my calculation i need a 12v 1Amp power supply? This right?
Thanks, Tama.
Facebook
Twitter
Instagram