Sign in with
Sign up | Sign in
Your question

Watchguard XTM 535 configuration question

Tags:
  • Networking
  • watchguard
  • Configuration
  • Cisco
  • WiFi
August 18, 2014 1:35:35 PM

I have 5 cisco sg300-28. One of them is set to Layer 3 and the rest at layer 2. we have different networks
admin 10.0.1.x
mh 192.168.0.x
mh wifi 192.168.100.x
admin wifi 10.0.2.x

The 4 layer 2 switches are connected to the layer 3 which are all used for the 10 network. I am trying to add the mh network. I have 2 servers connected and have the ports configured to the correct vlan for the 2 servers, ports 13 - 15. Currently i have port 15 going to the watchguard firewall for internet access for the mh network. Internet works fine with gateway set to 192.168.0.1, but i am unable to talk to the admin network. However if i change my GW to the switches ip address 192.168.1.250 and change GW on my laptop to admin switch ip address i can talk to them both, but get no internet.

Currently have it now setup using the GW from the interface of the firewall. Admin uses 10.0.1.2 and MH uses 192.168.0.1

On my laptop, i can ping 192.168.0.1, but cannot ping any of the 2 servers

On the server side, i cannot even ping 10.0.1.2

What would be causing this issue. Cisco thinks this could be the Watchguard Firewall causing this. So i added 2 policies with any traffic from 192.168.0.0/24 to speak to 10.0.1.0/24. Made 2 rules 10 to 192 and 192 to 10.

Still no luck.

Anyone out there that has ever seen or been thru this type of issue before.

Thanks,
Mike

More about : watchguard xtm 535 configuration question

!