Hi Still a newbie at VLANs!
Switches Im working on have all been configured previously. I need a new VLAN.
I have created a VLAN 290 on the stack (192.168.241.254 (GW))
On that switch I have connected my Windows server and untagged the ports needed. I can get a ip address from the DHCP on the server. My issue is that I have another switch previously configured and is routing between VLANs. I want to allow a port on this switch in the other location to get an ip address from the DHCP server in the 192.168.241.0 range. There is also a sonicwall in the mix.
Do I have to create a rule route on the sonicwall to allow traffic through or can this be done switch to switch?
I can ping the stack 192.168.35.1 from the remote switch and I put in a route on the remote switch for 192.168.241.0 go to 192.168.35.1.
Any pointers would be very helpful.
Regards
Ian
Switches Im working on have all been configured previously. I need a new VLAN.
I have created a VLAN 290 on the stack (192.168.241.254 (GW))
On that switch I have connected my Windows server and untagged the ports needed. I can get a ip address from the DHCP on the server. My issue is that I have another switch previously configured and is routing between VLANs. I want to allow a port on this switch in the other location to get an ip address from the DHCP server in the 192.168.241.0 range. There is also a sonicwall in the mix.
Do I have to create a rule route on the sonicwall to allow traffic through or can this be done switch to switch?
I can ping the stack 192.168.35.1 from the remote switch and I put in a route on the remote switch for 192.168.241.0 go to 192.168.35.1.
Any pointers would be very helpful.
Regards
Ian