I built my first custom PC a few months ago and recently i noticed that when I shut down my PC at 10 P.M. for example and start it the next morning the time is still 10 P.M. and i have to set the time manually every time. The motherboard i use is an asus maximus vi formula
PC doesn't update time when off
- Thread starter WeFknRise
- Start date
1) Reflash the latest UEFI, using EZ Flash 2 or USB BIOS flashback.
2) When the system POSTs, enter UEFI. Once in UEFI power down the motherboard. Keep the PSU attached and "on". Only the motherboard is powered off and in "standby". You will see the MB standby lights on (boards with start buttons onboard will be lit). Standby does not mean the board is actually running, standby means the board has power, but you have not pressed the power button to turn it on. Make sure the board is off before you go to the next step in this list. You will know if it is off because if you leave it for 5 seconds it should not POST~BOOT - this means it is in standby.
3) Clear CMOS (Clear RTC) for 10 seconds. This will clear the Management Engine.
4) Power up the system, enter UEFI, set the clock and then save and exit.
5) Update MEI driver to Version 9.5.14.1724 in the OS.
6 )Carry on using the system as normal.
The above steps should fix the issue.
2) When the system POSTs, enter UEFI. Once in UEFI power down the motherboard. Keep the PSU attached and "on". Only the motherboard is powered off and in "standby". You will see the MB standby lights on (boards with start buttons onboard will be lit). Standby does not mean the board is actually running, standby means the board has power, but you have not pressed the power button to turn it on. Make sure the board is off before you go to the next step in this list. You will know if it is off because if you leave it for 5 seconds it should not POST~BOOT - this means it is in standby.
3) Clear CMOS (Clear RTC) for 10 seconds. This will clear the Management Engine.
4) Power up the system, enter UEFI, set the clock and then save and exit.
5) Update MEI driver to Version 9.5.14.1724 in the OS.
6 )Carry on using the system as normal.
The above steps should fix the issue.
gakukid991
Honorable
- Dec 27, 2013
- 177
- 0
- 10,690
TRENDING THREADS
-
Question should i put the new 3050 lp in a sff hp g3?- Started by jordanbuilds1
- Replies: 14
-
-
-
-
-
Facebook
Twitter
Instagram