Recently my hard drive stopped working it spins for 10 seconds then stops and my pc was not starting no beep sound nothing and then i changed sata cable and power cable still no luck then i tried my old drive which is WD 80gb and that hard drive works with no problem but if i connect both the hard drive again my pc wont start.
On the boot device menu it only shows my 80gb old hard drive not my 500 hard drive.
Is this possible that the problem can be because of pcb board??
What can be the possible solution?
On the boot device menu it only shows my 80gb old hard drive not my 500 hard drive.
Is this possible that the problem can be because of pcb board??
What can be the possible solution?