Sign in with
Sign up | Sign in
Your question

Hackintosh & Multibeast Help! OSX

Tags:
  • Mac OS X
  • Macintosh
Last response: in Mac Os X
Share
August 27, 2014 12:16:45 PM

Hello! So I have just built my first computer/ Hackintosh setup and I am running into some problems with Multibeast! Before I go any further, my computer specs are this; i7 4790k processor, gigabyte GA-z97x-UD3H motherboard, Nividia GEforce GTX 760 graphics card, 16gb of crucial ballistix ram, and a Western Digital 1 terabyte hard drive. I also have a 256gb SSD but that runs windows. I partitioned my 1tb drive 700gb for windows storage and 300gb for mac. I get everything installed and cant quite get the settings right for multibeast. I can bypass the boot0 error, but even after that it wont let me boot into my Mac. I know my audio setting for my motherboard but other then that I really have no idea how to set up the rest of multibeast. if someone could assist me through that process or link me to something that could it would be greatly appreciated! Thank you again

More about : hackintosh multibeast osx

September 10, 2014 9:08:02 AM

Your first problem may be the partition. Although this logically doesnt make sense that it should cause problems with OSX, this can cause issues when Multibeast/Unibeast attempts to install on a drive that's part OSX Extended, part MS-DOS.

Other than that, look in any problems with "AppleHDA.kext" on your hackintosh. I know with my UD3h board (Although it is z77, not z97), I had boot errors until I used "AppleHDAkiller" and then "generic audio" from Multibeast.

Let me know if that works!
m
0
l
!