- Aug 29, 2014
- 6
- 0
- 4,520
can you help me sir... i encounter a problem with my PC.... the problem is no post indicator or no beeps...
the history was when i played LAN games it works properly no sign of bad problem and its fine after i turn it off to go to bed.. then this today i turn on my pc and it fail to post ..
no display on monitor...
Iv'ed done all the steps that i know...
1: i restart it for many times.. ( failed )
2: i remove all the inside parts like front panel USB, and others... ( failed)
3: i remove the cmos battery with in a minute then i re-insert it. ( failed)
4: i reset CMOS jumper. ( failed)
5: i switch the jumper 1 and 2 pin to place it in 2 and 3 pin. ( failed)
6: i start up the PC without cmos. ( failed )
7: when i remove the ram it response 1 long 2 short beeps... but when i re-insert the ram it didn't response... i try replacing it with borrowed ram but no post indicator.. i do it in 1st and 2nd ram slot ...
what should i do..? can you give suggestion sir?
the history was when i played LAN games it works properly no sign of bad problem and its fine after i turn it off to go to bed.. then this today i turn on my pc and it fail to post ..
no display on monitor...Iv'ed done all the steps that i know...
1: i restart it for many times.. ( failed )
2: i remove all the inside parts like front panel USB, and others... ( failed)
3: i remove the cmos battery with in a minute then i re-insert it. ( failed)
4: i reset CMOS jumper. ( failed)
5: i switch the jumper 1 and 2 pin to place it in 2 and 3 pin. ( failed)
6: i start up the PC without cmos. ( failed )
7: when i remove the ram it response 1 long 2 short beeps... but when i re-insert the ram it didn't response
... i try replacing it with borrowed ram but no post indicator.. i do it in 1st and 2nd ram slot ...what should i do..? can you give suggestion sir
?
.... i remove all the power source from 24 pin to 4 pin away from mobo or let say re-assembling it.. then i wait an half of hours then i move it back.. then i do this steps... i re-install the ram .. then i place the jumper settings to 2 and 3 pins after 1 minute i move it back.... next i put the cmos battery on its place... 
Facebook
Twitter
Instagram