Sign in with
Sign up | Sign in
Your question

receiver connection problem

Tags:
  • Connection
  • Audio
  • Homebuilt
Last response: in Home Audio
Share
September 1, 2014 5:19:42 PM

I need to know if there is a solution to my problem. during the construction of my house I ran all of my speaker wires through the house all 14/ 2. the problem is that the wires the should go from the volume control to the receiver should had been a 14/ 4. I noticed the problem a few months later. I cannot pull the wires as all of the holes were sealed by the builder to prevent fire flash. any way to do a wireless remote?

More about : receiver connection problem

September 2, 2014 10:06:51 AM

If you only have two conductors going into each room then you don't have a stereo signal for the speaker pairs. No remote can help you with this. You could place a Sonos ConnectAmp where the 14/2 wire from each speaker can be accessed. This will give you stereo and full control with smartphone, tablet, or computer. No home runs needed with Sonos.
m
0
l
!