Spilled soda on my desktop and now I can't get any video to display or any sounds?

SimplyBen

Distinguished
Jan 3, 2011
14
0
18,510
So over the last weekend I knocked a glass of sprite onto my desk and some leaked off the side where my desktop was sitting (with it's side panel open). The computer immediately froze up/shut down and I unplugged everything and shut off the power switch immediately. I didn't notice any damage to the parts on first glance so stupidly tried to power it on to no avail. I then got an old graphics card that had blown before (2+ years ago). To my surprise I got video display once it reached my desktop screen and the windows sound since I had my audio plugged in to try and hear anything.

Now I realize this was pretty stupid of me as there could have been massive liquid damage and fried the mobo/psu/gfx card/cpu or whatever but I was desperate and noticed no immediate damage anywhere. Not sure what to look for since the soda was sprite but I figured the liquid had probably hit the graphics card considering the location of the tower, but it's impossible to tell and it definitely wasn't much since most of it fell on the desk. From then I kept everything unplugged and removed all parts (ram, hard drive, graphics card, external devices, etc.) I left this off for about 48 hours and bought a new graphics card, thinking (no video probably meant my card was fried). I completely took apart the computer down to the cpu and inspected the motherboard very carefully, looking for busted cap thingies, any kind of acidic looking material or discolorations or abnormalities anywhere.

The only thing I could find that remotely looked out of the ordinary (apart from a lot of dust was a very very tiny outline of a shape resembling a poorly drawn circle in a light greyish color on a chip on the motherboard (the largest of several on there). I think I had actually noticed it there before many months ago when I had replaced my thermal paste and dusted out the computer.

Anyway, I dusted and did put some articlean also on that spec on the chip with a q-tip and dried it off with a clean cotton tea. I reapplied the thermal paste and put everything back together. Waited about 2 hours and tried again to power it on with the new graphics card. The computer powers on (the fans run, mobo/psu lights come on). I haven't set up the pin with makes the beeping sounds when you turn it on, so i might try that when I get home (just thought of that now). So while it is 'powered on' it will make a whirring sound every 15-20 seconds or so like it's trying to power on. It's very faint but a noticeable sound as if something is trying to start up.

I am concerned that maybe my mobo is in fact dead but I'd like to rule out everything else first since the mobo will end up costing me more than double any other part. I plan to go buy a new PSU today and return that new graphics card. The reason I suspect it might also be the PSU is because with the graphics card I was using, you had to plug in an extra 4 'pronged?' power cord from the PSU into it's side to help it run.

Whenever I did this with the extra power plugged in, the computer lights would flick on and the fans would spin 1 rotation and then immediately shut off. This suggests to me that maybe there is some power but for the most part it's blown/fried/whatever. The liquid very easily would have reached the PSU from the open sided desktop with the big PSU being on the left with an very open spiral top to it. The liquid would have had to splash and in a weird angle to reach anything else except the graphics card. Someone had mentioned in another thread about a similar situation that just because the computer lights and fan come on, does not mean the PSU is necessarily working and that it could still power up fans and lights while not producing enough power to get anything else going. I'm hoping this is the case so I'm only out around $60-80 in stead of $150+ and having to order online (since no one carries local mobos).


Anyway, if anyone can give me insight on what they think I would appreciate it.

Lastly, I heard there's some hardware I can buy(on the cheap) that actually is supposed to detect which part of your computer has failed. What is this hardware and is it easily available or is it something I would have to get online or at a specialty store?

 
Solution
As far as cleaning up any spilled soda, try to locate any of the wet spots, clean the area thoroughly with isopropyl alcohol 70% to 80% works fine, use Qtips and swab the area with the alcohol.

As far as locating the problem hardware, try to swap out parts to test, start with the psu and work your way inward. PSU, MB, GPU, RAM, CPU.

I can tell you from experience that even a small amount of liquid can cause hardware to not work. I had a GPU that would bluescreen my computer from about 2 drops of liquid coolant that got on it. Thankfully after cleaning it up all was well.

goku1234567890

Distinguished
Look from my opinion i would strongly suggest taking it to IT store and tell them the whole story. They might charge some for the checkup but they will tell more accurately because they will have spare processors, mobo's, rams, cards. So basically they will try everything and will give you the confirm answer. On the other hand it seems to me the motherboard would be the first thing, but i can't say for the power supply. If you have a friend or extra pc lying at home you could check all the components one by one and eventually you will figure out what is wrong.
 

oxxfatelostxxo

Distinguished
Aug 17, 2007
157
0
18,710
As far as cleaning up any spilled soda, try to locate any of the wet spots, clean the area thoroughly with isopropyl alcohol 70% to 80% works fine, use Qtips and swab the area with the alcohol.

As far as locating the problem hardware, try to swap out parts to test, start with the psu and work your way inward. PSU, MB, GPU, RAM, CPU.

I can tell you from experience that even a small amount of liquid can cause hardware to not work. I had a GPU that would bluescreen my computer from about 2 drops of liquid coolant that got on it. Thankfully after cleaning it up all was well.
 
Solution

carlo_bigtunes

Honorable
Nov 18, 2013
349
0
10,960
motherboard series?
already tes psu? jumper on green and black cable?is it ok
test motherboard only, (no cpu, ram , hdd etc) MB + psu 24 pin and 4/8 pin

try this to detect motherboard failure coz of short eclectric.
plug 24 pin without 4/8 pin, power on psu..is fan spin or not? if spin
with motherboard power on , plug carefully 4/8 pin. is there any splash electric then mb shut off or not.

if motherboard shut off, then one of mb part had short / broken ,
espesially MOSFET broken.

i already answer this motherboard problem with spin fan 1 second then shut off in this forum and how to trace the problem.

don't worry to do that, it's save. i already doing this to check motherboard short a lot.

sorry for my bad english.
 

SimplyBen

Distinguished
Jan 3, 2011
14
0
18,510
I will update you guys tonight on if my new PSU fixes things. I am also planning to overnight a mobo as soon as I find out if the PSU was the problem. As for cleaning the parts, I have been quite thorough and notice no liquid on my mobo but am not even sure what a few drops would look like. As far as I can tell, there is nothing out of the ordinary or splotchy anywhere but that one tiny grey ring on the largest of the black chips, but I believe that was there months ago too and it may be even supposed to be there.

I would rather not go to an IT place to test it as that will take even more time than my current situation since I do not have access to a car and would have to wait till at least Sunday to have someone willing to spend the time to go do that, not to mention they will probably charge me half as much as it would be to just buy the parts which I could return (such as the PSU) if it turns out it's not the problem. I suppose the worst case scenario would be if multiple parts were the problem.

And I will try to decipher what you said Carlo. I'll have to google what the the 24 pin vs 4/8 pin is and try that out. I have added a picture of my mobo. Can you verify those are the pins you are talking about? I also drew where the tiny gray circular thingy has been. The motherboard is MSI 870A-G54 AM3 AMD 870

vA3Qfcz.jpg