HI,
I just bought the Bitfenix Alchemy (Orange 60cm x30LED) for my NZXT H440 (Black/Red).
I was wondering if i could connect it with the O/I switch, so that i can control the lights.
I looked into it with my h440, and it doesn't seem to work. The board is only designed to house the two I/O lights. Honestly your best bet is to either just run the Alchemy 24/7 or pick up a set of these: http://www.newegg.ca/Product/Product.aspx?Item=N82E16811994001
They are surprisingly well built and bright. They put off very little heat and they light the case up great! They're cheap enough to buy a few colors if you want too.
And what's great about those is they come with an On/off switch which mounts in one of your expansion slots (check the pics on newegg too see what i mean).
There is likely some LEDs with the same setup but honestly, for 6$ (got them on sale) i can't complain and it looks great
I looked into it with my h440, and it doesn't seem to work. The board is only designed to house the two I/O lights. Honestly your best bet is to either just run the Alchemy 24/7 or pick up a set of these: http://www.newegg.ca/Product/Product.aspx?Item=N82E16811994001
They are surprisingly well built and bright. They put off very little heat and they light the case up great! They're cheap enough to buy a few colors if you want too.
And what's great about those is they come with an On/off switch which mounts in one of your expansion slots (check the pics on newegg too see what i mean).
There is likely some LEDs with the same setup but honestly, for 6$ (got them on sale) i can't complain and it looks great