Hello everyone. I've decided to try and figure out this issue again. I've got myself a home theater PC (windows 7- 64) which connects to my Yamaha receiver which in turn connects to my epson projector. All through HDMI hookups through my AMD video card (Diamond Radeon HD 7750). In my sound playback options, I have AMD high definition audio device which normally shows my av receiver with my current 5.1 surround. If I go to the configure speaker options and see or select 5.1 then my system works fine. Anytime I turn off my receiver, my projector audio is then detected which is only 2 speakers and the AMD high definition audio device then shows my Epson projector and switches to stereo sound. If I turn back on my receiver, the AMD high definition audio switches back to my receiver but the previous settings are lost. Anything I set up including 5.1 surround or a different audio bit/hertz format are lost. I've looked this up before and I couldn't figure it out. The best I could find was a program that switches the audio back to 5.1 by pressing a key combo. I've looked this up and couldn't find anyone that had really found a solution. Any help on this would be appreciated.