I am building a pc, and the 24 pin power connector from the PSU won't go all the way into the Mobo so that there is a half a mm to a mm gap in between the between the edges of the plastic,
There is just enough of a gap so that the clip won't set in place. The 24pin connector is very firmly set though and takes quite a bit of force and wiggling to remove it. Can I leave leave it as is since it is so firmly in place? ( I have already applied quite a bit of force and I doubt it will go in further without breaking something) or should I try applying more force till the pin clicks in and there is no gap? Also the mobo only seems to have only one power plug that says its for case fans, and the only other thing that has three pins that looks like a fan connector is the JUSB_pw1 is that usable? if not what is that plug for? Thank you for your time and help.
There is just enough of a gap so that the clip won't set in place. The 24pin connector is very firmly set though and takes quite a bit of force and wiggling to remove it. Can I leave leave it as is since it is so firmly in place? ( I have already applied quite a bit of force and I doubt it will go in further without breaking something) or should I try applying more force till the pin clicks in and there is no gap? Also the mobo only seems to have only one power plug that says its for case fans, and the only other thing that has three pins that looks like a fan connector is the JUSB_pw1 is that usable? if not what is that plug for? Thank you for your time and help.