- Aug 11, 2014
- 38
- 0
- 4,530
So, i was overclocking on Asrock Z87 Killer- G3258 and Geil Evo Veloce gev38gb1600c9dc.
I started clocking the ram. The CPU was at 4.2ghz and 3.6 uncore. Stable working.
So, i get in the bios and set the timings to 11-12-11-33, 1.65v and 1866mhz. It boots and it's stable.
Next try - 2000...
BIG mistake.
After saving settings, the pc shut down and didn't want to turn on. Only the mouse is lighting.
I turn the PSU off and reset the uefi with the jumper. Does not start again.
I got the ram out and reset it again, then put it back in. It starts, but...
...the keyboard is a bit freaked out. Only numbers 5 and 6 work now on the bar above the letters. The numpad ones work, but the others- dont.
They worked before the crap happened.
Any ideas ?
I have no other keyboards around.
The keyboard is PS2.
I started clocking the ram. The CPU was at 4.2ghz and 3.6 uncore. Stable working.
So, i get in the bios and set the timings to 11-12-11-33, 1.65v and 1866mhz. It boots and it's stable.
Next try - 2000...
BIG mistake.
After saving settings, the pc shut down and didn't want to turn on. Only the mouse is lighting.
I turn the PSU off and reset the uefi with the jumper. Does not start again.
I got the ram out and reset it again, then put it back in. It starts, but...
...the keyboard is a bit freaked out. Only numbers 5 and 6 work now on the bar above the letters. The numpad ones work, but the others- dont.
They worked before the crap happened.
Any ideas ?
I have no other keyboards around.
The keyboard is PS2.
Facebook
Twitter
Instagram