Sign in with
Sign up | Sign in
Your question

No display after reseating ram.

Tags:
  • Display Panels and Monitors
  • RAM
  • Graphics Cards
  • Display
  • Homebuilt
Last response: in Graphics & Displays
Share
September 15, 2014 7:35:38 PM

Hey guys,

So my pc was working fine and everything was sweet until I decided to test some ram all went downhill from there.

I pulled out the graphics card a Windforce 290x, to gain better access to ram. Also the HDD light and LED's on the front were not working since I built it just placed them in wrongly. So I reseated all those cables. Found that 2 pins were not working on the header. ( no idea if relevant to the problem or not )

I placed the old Corsair RAM in its DDR3 so thats ok, to test them. Placed everything back and no display. Reset CMOS took out battery waited a few min tried again. Nothing.

Placed my original G Skill Rip Jaw ram back in and everything back to how it was hoping that would fix it. Nothing still. Boots fine just no display.

I have tried takin everything out and running off onboard display still nothing. Just seems so weird kind of like this RAM has kiled my computer :( 

Specs;
550w G series Seasonic PSU
8gb DDR3 G Skill Rip Jaws
i5 4670k with Corsair H60 Liquid cool
6 HDD and 1 SSD which is running windows.
Windforce 290x

More about : display reseating ram

a c 209 U Graphics card
a b B Homebuilt system
September 27, 2014 8:55:19 PM

GPU plugged in fully - power cables attached? Might try the iGPU (on-board video, boot to BIOS and check that primary graphics is set to PCI-E, PEG
m
0
l
!