Hard Drive S.M.A.R.T. result help

devilhanzou

Distinguished
Apr 15, 2009
128
0
18,690
these were the categories: attribute threshold value worst status data

1,Raw Read Error Rate,51,200,200,OK,000000000002,0,Enabled
3,Spin Up Time,21,147,139,OK,000000000E29,0,Enabled
4,Start/Stop Count,0,98,98,OK (Always passing),000000000B46,0,Enabled
5,Reallocated Sectors Count,140,200,200,OK,000000000000,0,Enabled
7,Seek Error Rate,0,200,200,OK (Always passing),000000000000,0,Enabled
9,Power On Time Count,0,83,83,OK (Always passing),000000003331,0,Enabled
10,Spin Retry Count,0,100,100,OK (Always passing),000000000000,0,Enabled
11,Drive Calibration Retry Count,0,100,100,OK (Always passing),000000000000,0,Enabled
12,Drive Power Cycle Count,0,98,98,OK (Always passing),000000000AFC,0,Enabled
192,Power off Retract Cycle Count,0,200,200,OK (Always passing),0000000000BB,0,Enabled
193,Load/Unload Cycle Count,0,200,200,OK (Always passing),000000000A8A,0,Enabled
194,Disk Temperature,0,103,100,OK (Always passing),000000000028,0,Enabled
196,Reallocation Event Count,0,200,200,OK (Always passing),000000000000,0,Enabled
197,Current Pending Sector Count,0,200,200,OK (Always passing),000000000000,0,Enabled
198,Off-Line Uncorrectable Sector Count,0,200,200,OK (Always passing),000000000000,0,Enabled
199,Ultra ATA CRC Error Count,0,200,200,OK (Always passing),000000000000,0,Enabled
200,Write Error Rate,0,200,200,OK (Always passing),000000000001,0,Enabled

Any information on if my hard drive is okay or not would be great
 
Solution
Is there a question in there somewhere? The formatting makes it difficult to read. Every line reads OK, so not sure what your problem/question is.

devilhanzou

Distinguished
Apr 15, 2009
128
0
18,690
ya i was not sure the best format to use to make it easier to read, but really you answered my question. Just suddenly had computer slow down problems today which never happens so was worried it was my drive.