I currently have a gateway fx6800-01e and have installed a new amd r9 270x graphics card into it. My previous graphics card only had 1 6 pin connector running to it from the power supply so I plugged it into that and took one of the 6 pin connectors it came with and plugged it into the molex connector that was hanging around by it. this is my first time attempting to do this and i think that may have caused the problem?
I have researched on the forum though and there has been a lot of complaints about vista compatibility with the card. Currently both of the fans are running on the card so I think it might not be the power supply issue and just a driver issue with vista.
when i installed the catalyst control center and try and open it i get the message "AMD Catalyst Control Center cannot be started. There are currently no settings that can be configured using AMD Catalyst Control Center"
I have researched on the forum though and there has been a lot of complaints about vista compatibility with the card. Currently both of the fans are running on the card so I think it might not be the power supply issue and just a driver issue with vista.
when i installed the catalyst control center and try and open it i get the message "AMD Catalyst Control Center cannot be started. There are currently no settings that can be configured using AMD Catalyst Control Center"