Sign in with
Sign up | Sign in
Your question

Getting out of start up failure cycle on safe mode

Tags:
  • Reboot Loop
  • Safe Mode
  • Windows 7
Last response: in Windows 7
Share
October 4, 2014 12:58:27 PM

Im stuck in an endless start up cycle of safe mode with networking. Every time i tell it to start windows normally (after pressing f8) it ignores the command and just continues booting in safe mode with networking. This is the result after trying to enter safe mode with networking by setting it up in the system configuration panel. Then while it was entering it pressing f8 expecting something to happen because i couldn't see any start up happening, even though i heard the bios and the computer start up. Hearing a clicking sound a few times, then pressing Esc (hearing some more clicking sounds)and hearing the bios beep and start again.I fixed the start up problem to be able to see the start up happening. But now its just going in the never ending loop described earlier, and now i cant get out of this cycle, please help.

More about : start failure cycle safe mode

a c 363 $ Windows 7
October 5, 2014 1:22:54 AM

Trying hard to work through your maze of confusing information.

In Safe Mode, open the System Configuration Editor again and reverse whatever startup changes you made.
Then restart.
m
0
l
October 5, 2014 3:42:08 AM

Phillip Corcoran said:
Trying hard to work through your maze of confusing information.

In Safe Mode, open the System Configuration Editor again and reverse whatever startup changes you made.
Then restart.


Unfortunately i cant do that, as i found the root of the problem which is that the hard disk partition table got corrupted, now im trying to fix it by reinstalling, the hard disk's driver. Thank you for the suggestion though.
m
0
l
Related resources
!