So I just built my new rig. I would say everything went well except for the fact that the CPU temps are ridiculously high. I've attached pictures for the idle temps below. While running a few games to stress test it, the temp reached 80ºC, at which point I shut the computer down to cool off. The outside temp was at about a maximum of 24ºC at the time of testing and I had the air conditioning on the entire time but it didn't really help in anyway.
The CPU that was used was a brand new sealed i7-2600k which had been bought 3 years ago but never used up till now. Its in mint condition. I've used the stock hsf that came with it for now since I planned to overclock the CPU in the future with an aftermarket cooler.
I guess the likely issue could be the thermal paste or an incorrect hsf installation. I installed the stock hsf with the stock thermal compound and made sure the arrows were pointing away from the heat sink and that the black latch underneath the motherboard came all the way out to lock it in place.
As far as the airflow is concerned - I have 200mm front intake fan, 200mm top exhaust fan and a 120mm rear exhaust fan installed.
Rest of the details of my rig are as follows:
1. CPU - i7-2600k
2. Motherboard - Gigabyte Z77X UD5H
3. GPU - Sapphire R9 270X 2GB GDDR5 OC WITH BOOST
4. Case - CM 690 III
5. PSU - Cooler Master G650M
6. RAM - Corsair Vengenance 8GB DDR3 1600
Any advice would be good advice at this point. If you need any other details, let me know. Whatever suggestions you guys make, keep it as detailed as possible so that I know where to go with it. Thanks
The CPU that was used was a brand new sealed i7-2600k which had been bought 3 years ago but never used up till now. Its in mint condition. I've used the stock hsf that came with it for now since I planned to overclock the CPU in the future with an aftermarket cooler.
I guess the likely issue could be the thermal paste or an incorrect hsf installation. I installed the stock hsf with the stock thermal compound and made sure the arrows were pointing away from the heat sink and that the black latch underneath the motherboard came all the way out to lock it in place.
As far as the airflow is concerned - I have 200mm front intake fan, 200mm top exhaust fan and a 120mm rear exhaust fan installed.
Rest of the details of my rig are as follows:
1. CPU - i7-2600k
2. Motherboard - Gigabyte Z77X UD5H
3. GPU - Sapphire R9 270X 2GB GDDR5 OC WITH BOOST
4. Case - CM 690 III
5. PSU - Cooler Master G650M
6. RAM - Corsair Vengenance 8GB DDR3 1600
Any advice would be good advice at this point. If you need any other details, let me know. Whatever suggestions you guys make, keep it as detailed as possible so that I know where to go with it. Thanks