Cisco Aironet 1310

choore

Reputable
Oct 20, 2014
5
0
4,510
I have Cisco 1310 wireless bridge and i don't know how but its operating system is not working any more i have the operating system in Tar file but when i try to upload it to the bridge it gives me the below message and i cant figure out what the problem is please help me

bridge: tar -x tract://10.1.1.3/c1310-k9w7-tar.123-11.JA1.tar flash:
usage: tar <-table | -x tract> <tar file> <destination>
 

kanewolf

Titan
Moderator


The multiple periods in the the file name might be confusing it. Try renaming the file to an "8 dot 3" file name -- an 8 character long name ".tar" and retry. Boot loaders aren't always the smartest code.....
 

choore

Reputable
Oct 20, 2014
5
0
4,510
Hi Thanks for your reply i dont have much knowledge on this kind of configurations but as my understanding on what you recommended i have changed the .tar file to "abcd-con.tar" rather than "c1310-k9w7-tar.123-11.JA1.tar" and still it is the same it shows usage: "tar <-table | -x tract> <tar file> <destination>"
let me tell you the whole config if there is something wrong that i have done you can check it
i have installed a tftp in my computer and assigned my computer IP Address- 10.1.1.2 Subnet 255.255.255.0 and Default GAteway 10.1.1.1 and on the other hand i have set the wireless bridge an IP address 10.1.1.1 Subnet 255.255.255.0 and default Gateway 10.1.1.2.
 

kanewolf

Titan
Moderator


I think the syntax should be tar -x tftp://10.1.1.3/c1310-k9w7-tar.123-11.JA1.tar
The tract is just part of the "xtract" command ....
 

kanewolf

Titan
Moderator


The tftp address should be the workstation that has the tftp server on it which is 10.1.1.2 not 10.1.1.3 -- I didn't notice that discrepancy on the first read ...