- Nov 15, 2014
- 14
- 0
- 4,510
Hello,
Currently I'm using this motherboard as a replacement for my previous MSI P67A GD65. Unfortunately I have this booting issue with my SSD which kind of troublesome. When I first using it it does not cause any problems even though I wasn't doing fresh install of my windows 8. It was about a week later that this "reboot and select proper boot device" appears. This usually happens when my SSD is plugged to SATA3 port. When I changed to SATA2 port it still occasionally won't boot although not as frequent as when it was plugged to SATA3.
Basically whenever I turn on my computer I had to cross my fingers and hope that it would boot. If its not I had turn off my computer and try to either change the SATA cable, change its SATA port or unplugged the SATA cable on my SSD and plugged it again and turn it on. Sometimes it need 2-3 tries to get it worked.
What causes this problem? Is there any kind of fix to cure this problem? I hate to RMA this board because I'm using on board graphic and it will take quite some time before it returned to me.
Thanks in advance.
BTW here is my current system:
Intel 3770 non K
Asus P8Z77 V LK
Intel 520 120gb SSD
Intel HD graphics 4000
Corsair TX650 V2
Kingston hyperx fury ddr3 1600 RAM 16gb
Prolimatech megahalems
Coolermaster CM690 III
Currently I'm using this motherboard as a replacement for my previous MSI P67A GD65. Unfortunately I have this booting issue with my SSD which kind of troublesome. When I first using it it does not cause any problems even though I wasn't doing fresh install of my windows 8. It was about a week later that this "reboot and select proper boot device" appears. This usually happens when my SSD is plugged to SATA3 port. When I changed to SATA2 port it still occasionally won't boot although not as frequent as when it was plugged to SATA3.
Basically whenever I turn on my computer I had to cross my fingers and hope that it would boot. If its not I had turn off my computer and try to either change the SATA cable, change its SATA port or unplugged the SATA cable on my SSD and plugged it again and turn it on. Sometimes it need 2-3 tries to get it worked.
What causes this problem? Is there any kind of fix to cure this problem? I hate to RMA this board because I'm using on board graphic and it will take quite some time before it returned to me.
Thanks in advance.
BTW here is my current system:
Intel 3770 non K
Asus P8Z77 V LK
Intel 520 120gb SSD
Intel HD graphics 4000
Corsair TX650 V2
Kingston hyperx fury ddr3 1600 RAM 16gb
Prolimatech megahalems
Coolermaster CM690 III
Facebook
Twitter
Instagram