BSOD After installing new hardware.

Toggle sidebar Toggle sidebar
A

Akiba720

Reputable
Nov 6, 2014
20
0
4,510
Hello every one, i am in need of some help. I just got all my parts from newegg in the mail, i installed them into my case. The computer booted but while it is loading windows i get a BSOD code is STOP 0x0000007B. What could be causing this? Any help would be amazing. The new hardware is as follows.
GPU: Asus GTX 780 Ti(Drivers already installed had this card a few weeks)
CPU: AMD FX 8350
RAM: 4x4gb DDR3 1600
Motherboard:GA-990FXA-UD3
212 Hype Evo cooler.
750w PSU
 
Solution
J
ya sounds like too many new parts and windows is rejecting it if you replaced the motherboard with something other than a exact replacement of the one windows was installed on this could be your issue -- you can get by with a new chip and a card but a motherboard swap most times requires a clean install of windows and reactivating it
Sort by date Sort by votes
A

Akiba720

Reputable
Nov 6, 2014
20
0
4,510

This is a old build i am just upgrading it, I have the same Windows 7 install as i did before upgrading. How do i check if the board is Rev 4?
 
Upvote 0 Downvote
J

junkeymonkey

Polypheme
BANNED
Nov 11, 2013
17,389
4
66,960
ya sounds like too many new parts and windows is rejecting it if you replaced the motherboard with something other than a exact replacement of the one windows was installed on this could be your issue -- you can get by with a new chip and a card but a motherboard swap most times requires a clean install of windows and reactivating it
 
Upvote 0 Downvote
Solution
A

Akiba720

Reputable
Nov 6, 2014
20
0
4,510



Well alright i will get on that, and i will give a update later.
 
Upvote 0 Downvote
J

junkeymonkey

Polypheme
BANNED
Nov 11, 2013
17,389
4
66,960
GA-990FXA-UD3 (rev. 1.0) rev. 4.0rev. 3.0rev. 1.2rev. 1.1

you see these a few revisions of this board so for support for the correct board you need to know what one you got -- now it should state this on the main bios screen and its showen on the motherboard if you look at the pic of the boards birds eye view and magnified the top left corner on the left side of where it says designed in Taipei just above the stand off hole you can see it shows that board is a rev 1.0

http://www.gigabyte.com/products/product-page.aspx?pid=3894#ov


do the same here and see its a rev 4

http://www.gigabyte.com/products/product-page.aspx?pid=4672#ov
 
Upvote 0 Downvote
A

Akiba720

Reputable
Nov 6, 2014
20
0
4,510


Sorry about not replying sooner, i fixed the problem thanks to you just needed to reinstall windows. Now i need to learn to overclock lol.
 
Upvote 0 Downvote
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom