djjordand6 :
photonboy :
Yes, though that power supply apparently has noted quality issues.
I'd recommend something like this:
http://pcpartpicker.com/part/antec-power-supply-hcg520m
You should at least read THIS:
http://www.tomshardware.com/forum/id-1804779/power-supply-unit-tier-list.html
The one you have recommended does not fit in PC. It is 150 x 160 x 86mm
Hi - It should fit. The 160mm is the length of the PSU (not the width or ht), the other
two dimensions are std ATX measurements. So unless the current PSU is flush up against something
with no clearance, than I think it would fit. You are the best judge of this by looking in the case and
visually judging if you have 20mm of clearance, or 160mm from the rear panel (where PSU mounts)
to the 1st obstruction.
By the way - the cx600 will run your system with either of those GPU's.