ok so I bought this PWM 4-fan splitter, and am going to finish my build tomorrow,here's the page of the splitter: http://www.gelidsolutions.com/products/index.php?lid=2&cid=11&id=63&tab=1
my question is, I thought it was broken at first since it had 4 headers, with only one header that had 4 pins with a label "fan speed signal", and the other three headers had like 2pins beside each other then empty space in the place of a third pin, and then the 4th pin was there, so it only had 3 pins.
I haven't tried it out yet but, just to be sure, I am gonna have 4 120mm fans connected to it, and I want them all to be controlled by the CPU's temps, so should I plug any specific one to that 4 pins header that said "fan speed signal", and shouldn't the other 3 headers have 4 pins as well?
also, about the voltage, it has a molex connector with two wires into it so it's a 7v I guess, is that alright to take advantage of and put all 4 fans into it without any voltage issues? thanks
my question is, I thought it was broken at first since it had 4 headers, with only one header that had 4 pins with a label "fan speed signal", and the other three headers had like 2pins beside each other then empty space in the place of a third pin, and then the 4th pin was there, so it only had 3 pins.
I haven't tried it out yet but, just to be sure, I am gonna have 4 120mm fans connected to it, and I want them all to be controlled by the CPU's temps, so should I plug any specific one to that 4 pins header that said "fan speed signal", and shouldn't the other 3 headers have 4 pins as well?
also, about the voltage, it has a molex connector with two wires into it so it's a 7v I guess, is that alright to take advantage of and put all 4 fans into it without any voltage issues? thanks