How to reattach Z87-C pin socket cover?

Toggle sidebar Toggle sidebar
Solution
H
the plastic cover should be the same size as the cpu pcb so should fit perfectly. mate regardless of make and model all the brackets are the same size. there 1 of the few standards on a motherboard. they have to be because they will mount standardized cpu's.
the plastic goes under the mounting plate not on top so it shouldnt slip at all.

if you can take a picture of what your doing. 1 showing wherre your putting the plate and 1 with it slipping out.
it might give more insight.
Sort by date Sort by votes
H

HEXiT

Champion
Mar 13, 2011
10,957
13
51,965
if theres a cpu in the socket you dont.
if you have removed the cpu then you just lift the pressure bracket. slip the plastic under it and close. then lock it down as if you were locking down the cpu.
it may take a little presure to get it to close properly, but dont be overly forceful.

 
Upvote 0 Downvote
Z

zsfhstjhtgfdghn

Reputable
Dec 12, 2014
4
0
4,510

The plastic keeps falling off when I try to close the pressure bracket/load plate. Is this socket type (LGA1150) and Z87 chipset the same as one you have tried?
 
Upvote 0 Downvote
H

HEXiT

Champion
Mar 13, 2011
10,957
13
51,965
the plastic cover should be the same size as the cpu pcb so should fit perfectly. mate regardless of make and model all the brackets are the same size. there 1 of the few standards on a motherboard. they have to be because they will mount standardized cpu's.
the plastic goes under the mounting plate not on top so it shouldnt slip at all.

if you can take a picture of what your doing. 1 showing wherre your putting the plate and 1 with it slipping out.
it might give more insight.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom