I Have a wd1001faes sata 1tb drive it appears without taking it apart that the PCB is burnt - Ive read a few of these threads most of the the disk doesn't power up mine spins up fine and sounds normal PC bios even recognizes it as a 1tb sata drive smart capable and status bad tells me i need to back up but as soon as windows kicks in it just tells me hard drive failed i put it into a different windows PC it recognizes it as a drive but has no letter and the wmi can not populate it then after 5 min or so it disappears until i pull the leads out then put them back in Ive looked in to getting a replacement PCB there is one available however id have to swap out the bios - i wouldn't even know what that was let alone how to swap it - its imperative i retrieve what ever i can from this drive would it be better to just send it off any recommendations as to where? http://instagram.com/p/wvPZkQg0-1/ this is a pic of where the scorch marks are - right on 5 holes to of which are inside a gold circle looks pretty important???