My new pc has arrived but whenever I try to install the 970 drivers the screen will go blurry and these red lines will appear. See picture: http://imgur.com/FNL9SZV Also under device manager it has a yellow exclamation mark with this message: windows has stopped this device because it has reported problems. (code 43)
I have tried a lot of solutions such as : updating bios, trying different driver versions,restoring windows and turning off power. I also unplugged 970 and just used my on board 4600 intel hd it was fine but when I installed gtx 970 drivers it went back to being fuzzy
My build:
CPU: NEW! Intel Core i5 4690
CPU Cooler: Zalman CNPS10X Optima
Operating System: Windows 8.1 (64-bit)
Motherboard: NEW! Gigabyte Z97-HD3
RAM: 8GB Corsair 2133mhz Vengeance (2x4GB)
Hard Drive: Seagate 1TB (Hybrid 8GB SSD)
Optical Drive: 22x DVD±RW DL S-ATA
Graphics card: NEW! Asus GeForce GTX 970 4GB Strix OC
Sound card: Onboard 7.1 Audio
Internet: NEW! Wireless 802.11N 450Mbps MIMO PCI-E card
Case: Cooler Master 690 III
PSU: 600W Corsair CX
BenQ 24" XL2411Z 3D Gaming LED
please help
I have tried a lot of solutions such as : updating bios, trying different driver versions,restoring windows and turning off power. I also unplugged 970 and just used my on board 4600 intel hd it was fine but when I installed gtx 970 drivers it went back to being fuzzy
My build:
CPU: NEW! Intel Core i5 4690
CPU Cooler: Zalman CNPS10X Optima
Operating System: Windows 8.1 (64-bit)
Motherboard: NEW! Gigabyte Z97-HD3
RAM: 8GB Corsair 2133mhz Vengeance (2x4GB)
Hard Drive: Seagate 1TB (Hybrid 8GB SSD)
Optical Drive: 22x DVD±RW DL S-ATA
Graphics card: NEW! Asus GeForce GTX 970 4GB Strix OC
Sound card: Onboard 7.1 Audio
Internet: NEW! Wireless 802.11N 450Mbps MIMO PCI-E card
Case: Cooler Master 690 III
PSU: 600W Corsair CX
BenQ 24" XL2411Z 3D Gaming LED
please help
Facebook
Twitter
Instagram