AMD Catalyst Control Center has no options

PCnoobb

Reputable
Jan 2, 2015
4
0
4,510
Hi,
So I have a 2012 Vaio S series laptop, I5-2450 cpu, Intel HD 3000 and AMD HD 6470M graphics (which is now being detected as a HD 7400M). I did an update a while back from AMD and didn't notice till yesterday that there were no options in the Catalyst Center. I just finished removing all the drivers from AMD, downloaded the original one from sony, and then upgraded to the Catalyst Omega and still have the same problem of no options. While doing that update I got an error that said "The graphics driver cannot be detected or did not install properly ...... no settings can be changed at this time".... and that was about it! I was also looking at the KB3004394 issue since it had to do with the drivers etc but I have the updated patch apparently and nothing seems to be going wrong anywhere else, only the AMD center.
PLEASE HELP!
Thanks in advance
OH quick note I have looked through all posts and threads, tried basically everything and still nothing
 
Solution
D
You should stick with your old graphics driver from sony. I have a dell which also has switchable graphics ( hd3000 and amd hd 7450m). When i installed the new driver i got many errors when i switched between gpu's. And eventually i couldn't start amd catalyst controll center anymore.
D

Deleted member 1416470

Guest
You should stick with your old graphics driver from sony. I have a dell which also has switchable graphics ( hd3000 and amd hd 7450m). When i installed the new driver i got many errors when i switched between gpu's. And eventually i couldn't start amd catalyst controll center anymore.
 
Solution

PCnoobb

Reputable
Jan 2, 2015
4
0
4,510


Thanks, it went back to the way I wanted it, also another note updating the intel driver would also mess up the Catalyst Center! But factory drivers are good, running smooth again!