Hi there,
I recently installed a 3TB seagate barracuda last week to my build. Upon initial install, only 2 TB were showing up, so I partitioned using GPT and was able to see get the full 2.7 TB to show. However, in disk management, they were showing up as two separate drives: one with 2TB and one with 0.7TB. Since, I wanted to consolidate under one drive letter instead of two, I made them into a dynamic drive. Everything seemed fine and dandy for the next week or so, until yesterday, the power to my house shut off briefly and when the computer rebooted, checkdisk started to run, and when I got to windows, my latest hard drive was no longer visible. In disk management, the 0.7tb portion shows up as missing/failed.
So far, I've tried:
1.) removing and reinstalling the cables to the hard drive
2.) Going into disk management to try and reactivate the volumes
3.) I ran SeaTools to scan for problems and it passed all of them
4.) I ran minitool partition recovery, however, the drives show up as "bad disk" and I can't go on further
Is there anyway that I can recover the drive/files? or am I S.O.L.? Also, here's a screenshot of what the diskmanagement shows: http://i.imgur.com/OS76u5X.jpg
Thank you in advance!
I recently installed a 3TB seagate barracuda last week to my build. Upon initial install, only 2 TB were showing up, so I partitioned using GPT and was able to see get the full 2.7 TB to show. However, in disk management, they were showing up as two separate drives: one with 2TB and one with 0.7TB. Since, I wanted to consolidate under one drive letter instead of two, I made them into a dynamic drive. Everything seemed fine and dandy for the next week or so, until yesterday, the power to my house shut off briefly and when the computer rebooted, checkdisk started to run, and when I got to windows, my latest hard drive was no longer visible. In disk management, the 0.7tb portion shows up as missing/failed.
So far, I've tried:
1.) removing and reinstalling the cables to the hard drive
2.) Going into disk management to try and reactivate the volumes
3.) I ran SeaTools to scan for problems and it passed all of them
4.) I ran minitool partition recovery, however, the drives show up as "bad disk" and I can't go on further
Is there anyway that I can recover the drive/files? or am I S.O.L.? Also, here's a screenshot of what the diskmanagement shows: http://i.imgur.com/OS76u5X.jpg
Thank you in advance!
Facebook
Twitter
Instagram