I was installing the cooler master 240m last night. for the standoffs I only hand tightened them, and used a screw driver to mount the pump onto the standoffs, but one screw seemed to have a bad threading, so I took everything apart, that's when I noticed I "might" have used too much force with the screw driver, as the standoffs have sort of "dug" into the mobo, leaving a light circular mark on the mobo, you can kind of feel the dent with your finger tip. I was a bit worried, but put everything back together and apparently it boots up fine. I'm writing this post on the same pc. it had been over 12hrs, no crash, no failure, but I'm just wondering should I be worried and just get a new mobo?
-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
standoffs scratched motherboard
- Thread starter colinluca
- Start date
Solution
TRENDING THREADS
-
-
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session- Started by Admin
- Replies: 58
-
News Apple debuts M4 processor in new iPad Pros with 38 TOPS on neural engine
- Started by Admin
- Replies: 76
-
Question Samsung SSD showing as a Western Digital with only half of the storage space -- any fixes?
- Started by Frostsent
- Replies: 7
Facebook
Twitter
Instagram