- Jul 20, 2013
- 10
- 0
- 10,510
Hello.
So I decided to replace the stock thermal paste if my MSI GTX560 TI hawk graphics card and I put a little bit too much paste on and then it leaked out from the edge of the heatspreader of the GPU chip.
The problem is that a tiny bit of the Arctic MX-4 paste got between few of those pins on the bottom of the GPU chip. I am not able to get them out as they are between the PCB board and the chips heatspreader.
Is the mx-4 thermal paste any harm when it's stuck there?
Should I be worried? The card isn't connected yet.
Thank you
So I decided to replace the stock thermal paste if my MSI GTX560 TI hawk graphics card and I put a little bit too much paste on and then it leaked out from the edge of the heatspreader of the GPU chip.
The problem is that a tiny bit of the Arctic MX-4 paste got between few of those pins on the bottom of the GPU chip. I am not able to get them out as they are between the PCB board and the chips heatspreader.
Is the mx-4 thermal paste any harm when it's stuck there?
Should I be worried? The card isn't connected yet.
Thank you
Facebook
Twitter
Instagram