New Build Boot Issues, ASRock z97 Extreme6: 4f, 62, 99, a2, then nothing

Lucky Color Seven

Reputable
Feb 14, 2015
2
0
4,510
Hi all,

I'm admittedly not super knowledgeable, but I've just finished putting together a new build, and it's been a long time since I've done anything like this. Computer powers on, the fans are spinning, but I'm not getting signal on my monitor, and the little Dr. Debug thing flips through codes 4f, 62, 99, stays on a2 for a few second, and then the mobo lights turn off. The descriptions in the Dr. Debug manual are incredibly not specific (61-99, for example, are all apparently "Chipset Initialization Error", and it recommends to clear the CMOS, which I have). I really don't know where to go from here.

Parts List:

CPU: Intel Core i7-4790K 4.0GHz Quad-Core Processor
CPU Cooler: Cooler Master Hyper 212 EVO 82.9 CFM Sleeve Bearing CPU Cooler
Motherboard: ASRock Z97 EXTREME6 ATX LGA1150 Motherboard
Memory: Corsair Vengeance 8GB (1 x 8GB) DDR3-1866 Memory
Storage: Crucial MX100 256GB 2.5" Solid State Drive
Storage: Seagate Barracuda 2TB 3.5" 7200RPM Internal Hard Drive
Video Card: Asus GeForce GTX 780 3GB DirectCU II Video Card
Case: Fractal Design Define R4 w/Window (Black Pearl) ATX Mid Tower Case
Power Supply: Corsair CX 750W 80+ Bronze Certified Semi-Modular ATX Power Supply
Monitor: Acer GN246HL 144Hz 24.0" Monitor
 

Lucky Color Seven

Reputable
Feb 14, 2015
2
0
4,510


I got it working, and as it turns out, it was a really dumb mistake. As I went to switch the HDMI cable, I realized it was already plugged into the onboard slot. I switched it to the video card HDMI slot, and now everything's working fine. Thank you for inadvertently pointing out my stupidity. :p