Hey everyone,
This is my first build and I think I need some help on something that I can't find the answer to.
I purchased the Raijintek Tisis but am unclear as how to install correctly as it has a PWM fan and a 3 pin and not sure where to plug each fan into my Asus Sabertooth Mark 2. The MB has a 4 pin CPU Fan connector and a CPU OPT Fan connector, so I was planning on the PWM into the CPU Fan and the 3 pin connector into the CPU OPT Fan connector. Is this correct? If I go this route, will the 3 pin fan always run at full speed as it does not have the "control" wire?
Also, why would they mix 2 different types of fans?
List of parts below:
I5-4690k CPU
Raijintek Tisis Black
Asus Sabertooth Z97 Mark 2
Corsair Vengeance 8GB 1600
WD Caviar Blue 1 TB
PowerColor R9 290x
Phanteks Enthoo Pro White
EVGA 750W G2
Thanks in advance!
Steve
This is my first build and I think I need some help on something that I can't find the answer to.
I purchased the Raijintek Tisis but am unclear as how to install correctly as it has a PWM fan and a 3 pin and not sure where to plug each fan into my Asus Sabertooth Mark 2. The MB has a 4 pin CPU Fan connector and a CPU OPT Fan connector, so I was planning on the PWM into the CPU Fan and the 3 pin connector into the CPU OPT Fan connector. Is this correct? If I go this route, will the 3 pin fan always run at full speed as it does not have the "control" wire?
Also, why would they mix 2 different types of fans?
List of parts below:
I5-4690k CPU
Raijintek Tisis Black
Asus Sabertooth Z97 Mark 2
Corsair Vengeance 8GB 1600
WD Caviar Blue 1 TB
PowerColor R9 290x
Phanteks Enthoo Pro White
EVGA 750W G2
Thanks in advance!
Steve