New build :
CPU: Intel Core i5-4690K 3.5GHz Quad-Core Processor
Motherboard: ASRock Z97 EXTREME4 ATX LGA1150
Memory: G.Skill Ripjaws X Series 16GB (2 x 8GB) DDR3-2400 Memory
Storage: OCZ ARC 100 240GB 2.5" Solid State Drive
Storage: Seagate Barracuda 1TB 3.5" 7200RPM Internal Hard Drive
Video Card: EVGA GeForce GTX 980 4GB Superclocked ACX 2.0 Video
Case: Fractal Design Define R5 (Black) ATX Mid Tower Case
After : installing CPU + RAM + VIdeo Card I try to start the system with the on board power button. I hear something like a little click but nothing powers on.
the PSU is 600 watts and was working on my old system.
When I hit the CMOS reset button the board power on for like a second (fan start spinning vid card lights comes one) but then everything stops and the red led on the board is lit.
Dr. Debug flashes a code then nothing (I can see him going to 15 and then nothing)
What I’ve tried so far
1. Check if 24 pin and 12 volt are well connected
2. Changed the ram in different slots
3. Removed CPU and checked for bent pins (Visual inspection no magnifying glass)
4. Tested the PSU with paper clip (works).
Am I missing Something?
Is the board Dead? Or you guys think it's something else?
* UPDAte PSU is ok see post below also i breadboarded
CPU: Intel Core i5-4690K 3.5GHz Quad-Core Processor
Motherboard: ASRock Z97 EXTREME4 ATX LGA1150
Memory: G.Skill Ripjaws X Series 16GB (2 x 8GB) DDR3-2400 Memory
Storage: OCZ ARC 100 240GB 2.5" Solid State Drive
Storage: Seagate Barracuda 1TB 3.5" 7200RPM Internal Hard Drive
Video Card: EVGA GeForce GTX 980 4GB Superclocked ACX 2.0 Video
Case: Fractal Design Define R5 (Black) ATX Mid Tower Case
After : installing CPU + RAM + VIdeo Card I try to start the system with the on board power button. I hear something like a little click but nothing powers on.
the PSU is 600 watts and was working on my old system.
When I hit the CMOS reset button the board power on for like a second (fan start spinning vid card lights comes one) but then everything stops and the red led on the board is lit.
Dr. Debug flashes a code then nothing (I can see him going to 15 and then nothing)
What I’ve tried so far
1. Check if 24 pin and 12 volt are well connected
2. Changed the ram in different slots
3. Removed CPU and checked for bent pins (Visual inspection no magnifying glass)
4. Tested the PSU with paper clip (works).
Am I missing Something?
Is the board Dead? Or you guys think it's something else?
* UPDAte PSU is ok see post below also i breadboarded