Corsair H80i GT on a Maximus Vii Ranger motherboard with a i7 processor

Toggle sidebar Toggle sidebar
J

Jonnypollen

Reputable
May 4, 2015
1
0
4,510
Hi there, I've just built a computer with a Maximus vii Ranger LGA1150, with a intel i7-4790k. This is being cooled but a liquid cooled corsair h80i GT. when i first turn it on it runs fine at around 25-30 degrees, but if i turn it off and turn it back on again after about 5-10 mins it goes up to 88 degrees. Ive Reapplied the thermal paste and even put rubber washers on the fixings on the brackets so that there is no play in the cpu cooler, but still over heats, any suggestions ??
 
Solution
CorsairJoseph
If you are using Corsair Link SW, I'd check your pump's rpm and see if its dropping at some point. Quiet mode should be running around 2000rpm and 3000rpm in Performance mode. Those rpms in each mode should be constant and steady, they shouldn't be any huge fluctuations.
Sort by date Sort by votes
CorsairJoseph

CorsairJoseph

Reputable
Nov 7, 2014
300
0
4,960
If you are using Corsair Link SW, I'd check your pump's rpm and see if its dropping at some point. Quiet mode should be running around 2000rpm and 3000rpm in Performance mode. Those rpms in each mode should be constant and steady, they shouldn't be any huge fluctuations.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom